Configuring interface connections, 3 configuring interface connections – Asante Technologies 40240/40480-10G User Manual
Page 178
CLI – This example shows the connection status for Port 5.
Console#show interfaces status ethernet 1/5
27-9
Information of Eth 1/13
Basic information:
Port type:
1000T
Configuration:
Name:
Port admin:
Up
Speed-duplex: Auto
Capabilities:
10half, 10full, 100half, 100full, 1000full
Broadcast storm:
Enabled
Broadcast storm limit: 500 packets/second
Flow control:
Disabled
LACP: Disabled
Port security:
Disabled
Max MAC count:
0
Port security action:
None
Media type:
None
Current status:
Link status:
Down
Operation speed-duplex: 1000full
Flow control type:
None
Console#
Configuring Interface Connections
You can use the Port Configuration or Trunk Configuration page to enable/disable an
interface, set auto-negotiation and the interface capabilities to advertise, or manually
fix the speed and duplex mode, and flow control.
Command Attributes
•
Name – Allows you to label an interface. (Range: 1-64 characters)
• Admin – Allows you to manually disable an interface. You can disable an interface
due to abnormal behavior (e.g., excessive collisions), and then reenable it after the
problem has been resolved. You may also disable an interface for security
reasons.
•
Speed/Duplex – Allows you to manually set the port speed and duplex mode
(i.e., with auto-negotiation disabled).
Note:
The 1000BASE-T standard does not support forced mode. Always use
auto-negotiation to establish a connection over any 1000BASE-T port or trunk.
•
Flow Control – Allows automatic or manual selection of flow control.
•
Autonegotiation (Port Capabilities) – Allows auto-negotiation to be enabled/
disabled. When auto-negotiation is enabled, you need to specify the capabilities to
be advertised. When auto-negotiation is disabled, you can force the settings for
speed, duplex mode, and flow control. The following capabilities are supported.
-
10half - Supports 10 Mbps half-duplex operation
-
10full - Supports 10 Mbps full-duplex operation
-
100half - Supports 100 Mbps half-duplex operation
-
100full - Supports 100 Mbps full-duplex operation
8-3
Configuring Interface Connections
8