Asante Technologies 40240/40480-10G - Manual (Page 80)

Setting the Switch’s IP Address (IP Version 4)
Web – Click System, Bridge Extension.
Figure 4-3 Displaying Bridge Extension Configuration
CLI – Enter the following command.
Console#show bridge-ext
Max support VLAN numbers: 4096
Max support VLAN ID: 4093
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: No
Traffic classes: Enabled
Global GVRP status: Disabled
GMRP: Disabled
Console#
Setting the Switch’s IP Address (IP Version 4)
This section describes how to configure an initial IPv4 interface for management
access over the network. This switch supports both IPv4 and IPv6, and can be
managed through either of these address types. For information on configuring the
switch with an IPv6 address, see “Setting the Switch’s IP Address (IP Version 6)” on
page 4-9.
The IPv4 address for this stack is obtained via DHCP by default. To manually
configure an address, you need to change the stack’s default settings to values that
are compatible with your network. You may also need to a establish a default
gateway between the stack and management stations that exist on another network
segment (if routing is not enabled on this stack).
You can manually configure a specific IP address, or direct the device to obtain an
address from a BOOTP or DHCP server. Valid IP addresses consist of four decimal
4-5
4
34-2