Figure 4-12 setting the startup code, Figure 4-13 deleting files, Saving or restoring configuration settings – Asante Technologies 40240/40480-10G User Manual
Page 99
You can upload/download configuration settings to/from a TFTP server, or copy files
to and from switch units in a stack. The configuration file can be later downloaded to
restore the switch’s settings.
Command Attributes
•
File Transfer Method – The configuration copy operation includes these options:
- file to file – Copies a file within the switch directory, assigning it a new name.
-
file to running-config – Copies a file in the switch to the running configuration.
-
file to startup-config – Copies a file in the switch to the startup configuration.
- file
to
tftp – Copies a file from the switch to a TFTP server.
- running-config
to
file – Copies the running configuration to a file.
- running-config
to
startup-config – Copies the running config to the startup config.
- running-config
to
tftp – Copies the running configuration to a TFTP server.
- startup-config
to
file – Copies the startup configuration to a file on the switch.
- startup-config
to
running-config – Copies the startup config to the running config.
- startup-config
to
tftp – Copies the startup configuration to a TFTP server.
- tftp
to
file – Copies a file from a TFTP server to the switch.
- tftp
to
running-config – Copies a file from a TFTP server to the running config.
-
tftp to startup-config – Copies a file from a TFTP server to the startup config.
- file
to
unit – Copies a file from this switch to another unit in the stack.
- unit
to
file – Copies a file from another unit in the stack to this switch.
•
TFTP Server IP Address – The IP address of a TFTP server.
•
File Type – Specify config (configuration) to copy configuration settings.
•
File Name — The configuration file name should not contain slashes (\ or /), the
leading letter of the file name should not be a period (.), and the maximum length
for file names on the TFTP server is 127 characters or 31 characters for files on
the switch. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
•
Source/Destination Unit – Stack unit. (Range: 1 - 8)
4-24
To start the new firmware, enter the “reload” command or reboot the system.
Console#copy tftp file
TFTP server ip address: 10.1.0.19
Choose file type:
1. config: 2. opcode: <1-2>: 2
Source file name: V3.1.16.20.bix
Destination file name: V311620
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#config
Console(config)#boot system opcode:V311620
Console(config)#exit
Console#reload
Saving or Restoring Configuration Settings
23-11
23-16
22-4
Basic Management Tasks
4