Kp-300 panel indicators, Error input logged leds, Error input status leds – Gilderfluke&Co KP-300 Smart Brick Control Panel User Manual

Page 11

Advertising

Kp-300 Panel Indicators

There are sixty-one LED indicators and one or two LCD displays on the front of the

Kp-300. They are used as follows:

A) Error Input Logged LEDs

(One yellow LED for each Error Input)

(Fifteen LEDs total)

These are lit to show that an input has been logged as inactive for the

current show. Once an input which is open (green LED is not on) has been
logged, it will be ignored until it is logged as active again. This feature is
typically used to log seat belt inputs. A seat which is unoccupied will be
logged so that it canʼt cause an E-Stop or Pause if it changes state during
the show.

Seat belts can be logged at any time that the

Show Pause Reset Input

from the Smart Brick System is active. When this input is active, the safety
inputs can be logged by either pressing the

Log Belts button

or activating the

Remote Log Belts Input

by pressing

Remote Log Belts Button(s)

attached to

it. If you want to automatically log belts from the motion profile, just set the

Remote Log Belts Input

for Internal Power and attach the two wires for this