Gilderfluke&Co KP-300 Smart Brick Control Panel User Manual
Page 44
b) Enable the
to the Kp-300 just before mo-
tion start. Disable it just after motion end. This will enable a hy-
draulic Motion base so that it is able to start moving. This is usu-
ally done just before the movement is to start. It is then disabled
again just after the movement is ended. Removing the
will cause a hydraulic motion base to park itself.
Normally you ʻflyʼ the motion base to as close to ʻparkedʼ as you
can get before removing the
.
c) Turn OFF the Show Pause Reset Output at show start. Normally
this is ʻoffʼ throughout the show. While it is off, it is possible to
ʻpauseʼ the show. If you donʼt want anyone pausing the show at
the beginning or end of the show (before and after the time the
base is moving, you can extend the ʻShow Pause Resetʼ into the
show at the ends if desired. It can remain on until just before the
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Kp-300 Manual / September 4, 2012 4:29 PM / page 44 of 75
Beginning of ʻMainʼ Show