Gilderfluke&Co KP-300 Smart Brick Control Panel - Manual (Page 23)

input together so it is always active. Whenever the Show Pause Reset Input
is programmed active, the inputs that are set to be logged will automatically
be logged.
Input logging actually takes place at the instant that the Log Belts Button ,
Remote Log Belts Input , or Show Pause Reset Input are released. The LED
next to the Log Belts Button will light whenever the seat belts are being
logged.
C) Show Start Buttons
(Eight Buttons)
The Kp-300 has been designed to support up to eight shows which can
be directly accessed. If more shows are needed, these Show Start Buttons
can be bypassed with a Kp-100 or Kp-200 to allow access to the Smart Brick
Systemʼs 255 show capacity.
Which shows are available to the user (which of these eight Show Start
Buttons are enabled), is controlled as a function of the motion profile running
on the Smart Brick System. Enabling a Show Start Buttons just requires set-
ting the appropriate Show Start Button Enable Inputs in the motion profile.
Any or all of the Show Start Buttons can be enabled/disabled at any time.
The Show Start Button LEDs next to these buttons are also controlled as
part of the motion profile. This allows the Show Start Button LEDs to be pro-
grammed on, off or flashing as desired at any point in time.
Typically the Show Start Buttons are programmed as active during the E-
Stop and Load/Unload shows. During the main shows, typically none of
them are enabled. If any are enabled, then the user can jump directly out of
the currently running show and into the one(s) that have been enabled. This
is sometimes used to enable a ʻparkʼ show that brings the motion base home
without having to do anything as drastic as an E-Stop. Any show that is en-
abled while another show is running will be enabled even during a show
pause. Make sure that if you are using this technique, that the show that is
jumped into has the
Show Pause Reset Input set for at least a few frames at
the beginning. Otherwise the new show will begin running, but the Show
Pause functions of the Kp-300 wonʼt be reset (the
Show Pause LED will re-
main lit, and the next Show Pause event will be ignored). At the end of the
pulse on the
Show Pause Reset Input , the Kp-300 will check for an out-
standing Show Pause condition. If one still persists, then the new show will
be paused.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Kp-300 Manual / September 4, 2012 4:29 PM / page 23 of 75