Gilderfluke&Co KP-300 Smart Brick Control Panel - Manual (Page 42)

only the valid show selections. The eight ʻShow Pilotʼ outputs are
shown doing a simple circular chase pattern.
f) Whenever a Show Start Button LED is programed to indicate that a
Show Start Buttons is valid, it is also necessary to actually enable
the corresponding Show Start Button Enable Input from the Smart
Brick System to make the Show Start Buttons active. If this is not
done, then the Show Start Buttons will remain inactive. All eight
ʻShow Enablesʼ are ʻonʼ through the show, so all eight Show Start
Buttons are enabled.
g) The ʻ Show Pause Reset ʼ is ʻonʼ through the show to reset any po-
tential ʻpausesʼ.
h) The ʻBypass 2ʼ , ʻHPU Startʼ , ʻ HPU Stopʼ and ʻCycle Counterʼ are not
used during the Load/Unload show.
i) (optional) Open any cabin doors as needed. Sometimes cabin
doors are manually operated, sometimes they are automated. If
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Kp-300 Manual / September 4, 2012 4:29 PM / page 42 of 75