Gilderfluke&Co KP-300 Smart Brick Control Panel - Manual (Page 31)

ʻPauseʼ. Typically this is done during the E-Stop and Load/Unload shows to
prevent these shows from being paused.
F) Bypass Buss One
G) Bypass Buss Two
(One jumper for each safety input)
The fifteen Safety Inputs can be temporarily disabled from causing a
Show Pause or E-Stop from the motion profile programmed into the Smart
Brick System.
Bypass #1 Bypass #2
To keep an input from triggering a Show Pause/E-Stop when Bypass
Buss #1 is active, move the jumper to the middle and left two pins. To keep
an input from triggering a Show Pause/E-Stop when Bypass Buss #2 is ac-
tive, move the jumper to the middle and right two pins. If this feature is not to
be used on an input, remove the jumper altogether.
Typical examples of the use of the bypass buss are:
a) HPU Startup/Shutdown: If the HPU is started and stopped as
part of the motion profile, there will usually be a time just after it
is started and a time after it is stopped where any HPU pressure
sensors inputs will need to be bypassed. Do this by program-
ming the
Bypass Buss you are using and Remote HPU Start In-
put to be active at the beginning of the show. The Bypass Buss
needs to be active for the time it takes for the HPU to build up
pressure. If the pressure doesnʼt come up during the time allot-
ted, the Kp-300 will automatically trigger an error condition (ei-
ther E-Stop or Show Pause, as configured).
# If the HPU is to be turned off at the end of the show, then the
Bypass Buss which is being used would be programmed active
along with a pulse on the Remote HPU Stop Input . This allows
the HPU to be stopped without triggering an error condition. If
configured to trigger an E-Stop, the
Bypass Buss may also need
to be programmed active during the E-Stop and Load/Unload
shows so that the HPUʼs low pressure wonʼt trigger an error dur-
ing these shows when the HPU is off.
b) Door Sensors: If the door or floor mat sensors inputs are set to
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Kp-300 Manual / September 4, 2012 4:29 PM / page 31 of 75