Gilderfluke&Co KP-300 Smart Brick Control Panel - Manual (Page 48)

the list of shows that are to go into the AutoDownload. The order is
unimportant, but we usually put the E-Stop and Load/Unload shows
at the top of the list, and all the ʻMainʼ shows after. You can use the
promote/demote buttons to put the shows in any order you prefer.
Once all the shows are in the list in the order you would like, select the shows
one at a time to set what happens at the end of each:
a) ʻE-Stop 1ʼ jumps immediately to ʻE-Stop 2ʼ
b) ʻE-Stop 2ʼ jumps immediately to ʻE-Stop 2ʼ so it will loop on itself
c) All the ʻMainʼ shows jump immediately to the ʻLoad/Unloadʼ show at
their ends.
d) The ʻLoad/Unloadʼ show jumps immediately to ʻ Load/Unloadʼ so it
will loop on itself while waiting for the next show to be started
e) All shows need to be set to ʻCAN be stepped onʼ
3) Power Up Options: Start ʻE-Stop1ʼ show on startup
4) Input Actions: Assuming you are AutoDownloading to a Br-Brain4,
you will have ten inputs to set up:
a) Input 0: Closure = “Start” Main Show #1, Opening: “Not used”
b) Input 1: Closure = “Start” Main Show #2, Opening: “Not used”
c) Input 2: Closure = “Start” Main Show #3, Opening: “Not used”
d) Input 3: Closure = “Start” Main Show #4, Opening: “Not used”
e) Input 4: Closure = “Start” Main Show #5, Opening: “Not used”
f) Input 5: Closure = “Start” Main Show #6, Opening: “Not used”
g) Input 6: Closure = “Start” Main Show #7, Opening: “Not used”
h) Input 7: Closure = “Start” Main Show #8, Opening: “Not used”
i) Input Green: Closure = “Pause Show”, Opening: “Continue Show”
j) Input Blue: Closure = “Start” E-Stop 1, Opening: “Not used”
5) Device Serial Address: This will default to the serial address of your
target device, and you should leave this set there.
6) First Channel: This will default to the first channel in your site file
(this is shown next to the where you enter the address in the paren-
theses), or the settings on the last AutoDownload. Unless you have
added or removed channels from your site file since the last Auto-
Download using this site file, you should let Pc•MACs set this for you.
7) Last Channel: This will default to the last channel in your site file
(this is shown next to the where you enter the address in the paren-
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Kp-300 Manual / September 4, 2012 4:29 PM / page 48 of 75