Gilderfluke&Co KP-300 Smart Brick Control Panel User Manual
Page 45
motion base is going to start moving, a hair before the
is programmed ON. This output is turned back ON
as soon as the motion base has stopped moving, as soon as it is
safe for the riders to unbuckle their seat belts and start getting
ready to leave the capsule.
#
To automatically log seat belts from the motion profile, just set
for Internal Power and attach the two
wires for this input together so it is always active. Whenever the
is programmed active, the inputs that
are set to be logged will automatically be logged. If automatic
seat belt logging is being used, then the Seat belts will be logged
when this output is turned off.
d) (optional) If you are using the
features:
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Kp-300 Manual / September 4, 2012 4:29 PM / page 45 of 75
End of ʻMainʼ Show