Gilderfluke&Co KP-300 Smart Brick Control Panel - Manual (Page 25)

E) HPU Stop Button
This Button is used to reset the latch on the Kp-300 that turns on the HPU
Run Output . This is an optional feature. If you donʼt want the HPU to be
started and stopped remotely, just donʼt use this button.
The HPU Stop Button parallels the Remote HPU Stop Input from the
Smart Brick System.
F) Show Pause Button
This button is used to set the latch on the Kp-300 that sends a pause
command to the Smart Brick Brain through the Green ʻPauseʼ Output . This
latch can also be set by any error condition that has been configured to start
a Show Pause event. If the
Show Pause Reset Output from the Smart Brick
System is active, then the Show Pause latch can not be set by either this
button or an error condition.
When a show is paused, the Kp-300 sends a signal to the Smart Brick
Brain through its Green ʻPauseʼ Output . The Smart Brick Brain input must be
configured to pause the currently running show on a closure on this input 7 .
When a show is 'continued', the signal is dropped on the Green ʻPauseʼ
Output to the Smart Brick Brain. This input must be configured to continue
the currently running show on an opening on this input.
Once a show has been paused, the only two ways to 'continue' a show
are to:
a) Send an active signal from the Smart Brick System to the Kp-
300ʼs Show Pause Reset Input .
b) Once the condition that caused the Show Pause has been re-
moved, the operator can press the Show Continue button .
G) Show Continue Button
This button is used to reset the latch on the Kp-300 that sends a pause com-
mand to the Smart Brick Brain through the Green ʻPauseʼ Output . This latch can
also be set by any error condition that has been configured to start a Show Pause
event.
When a show is paused, the Kp-300 sends a signal to the Smart Brick Brain
through its Green ʻPauseʼ Output . The Smart Brick Brain input must be configured
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Kp-300 Manual / September 4, 2012 4:29 PM / page 25 of 75
7 In some applications, you may want to call up a different show using this input, instead of pausing the current show.