LEESON Micro Series Compact Inverters - Manual (Page 33)

13.2.2 MICRO SERIES DISPLAY IN RUN MODE
When the drive is in the RUN mode, the default display will look like this:
As in the STOP mode, the ENTER key can be used to toggle the display from SPEED to % LOAD to VAC
(motor voltage):
NOTE: During acceleration and deceleration to the SPEED set point, the DRIVE STATUS will show the
actual drive speed . When the SPEED set point is reached, the DRIVE STATUS will change to RUN (or
STOP if the drive is decelerating to a STOP).
31