LEESON Micro Series Compact Inverters - Manual (Page 47)

Once the correct password is entered, the PROGRAM mode will be entered and the first parameter will be
displayed, which is Parameter 0 - LINE VOLTS . This is shown below:
To scroll through the parameters, use the UP and DOWN arrow buttons on the keypad. When the desired
parameter is found, press the ENTER key to shift the cursor from the parameter name to the parameter
value. In this example, the cursor shifts from LINE VOLTS to HIGH:
The parameter value can then be changed using the UP and DOWN arrow buttons . If the parameter has a
numerical value, the UP arrow will increase the value and the DOWN arrow will decrease the value . If the
parameter has specific choices that can be selected, the UP and DOWN arrow keys will scroll through the
list of possible settings. When the desired value or option is selected, press the ENTER key to store the new
setting. If the new setting is not ENTERED, it will not take effect and the old setting will still be valid.
If the PROG/RUN key is pushed while the cursor is highlighting the parameter value, the value will change
back to the original setting (if it had been changed, but not ENTERED), and the cursor will shift back to
the parameter name. Pressing PROG/RUN again will exit the program mode. If the PROGRAM mode
is entered again within two minutes, the last parameter that was viewed, or changed, will come up on the
display . After two minutes has elapsed, the password will have to be entered again when attempting to access
the PROGRAM mode .
45