Yokogawa EJX930A - Manual (Page 131)

<8. Operation of DYFMVTool> 8-15
IM 01C25R51-01E
8.1.6 Apply Flow Configuration
Figure 8.15 Apply Flow Configuration Screen
In order to download the configuration to the device, click “Apply”.
Then perform “Download to Device” from Device DTM. (Refer to section 6.2.3)
Execute Apply for setting compensation condition in Offline.
Refer to Chapter 5 and Figure 6.3.
NOTE
Following shows “Device General Parameters” which is applied to “Offline Database”.
Table 8.8 “Device General Parameters” applied to “Offline Database”
Detail Compensation Mode
Gas temperature pressure
compensation (Detail)
Liquid temperature
compensation (Detail)
Arithmetic Type Applied Applied
Bias Applied (Always "0" ) Applied (Always "0" )
Gain Applied (Always "1" ) Applied (Always "1" )
Bias Input 1 Applied (Always "0" ) Applied (Always "0" )
Gain Input 1 Applied (Always "1" ) Applied (Always "1" )
Bias Input 2 Applied (Always "0" ) Applied (Always "0" )
Gain Input 2 Applied (Always "1" ) Applied (Always "1" )
Output Range.Unit Index Applied Applied
Volumetric Flow Unit Applied Applied
Temperature Unit — *1 — *1
Base Temperature — —
Pressure Unit — *1 —
Base Pressure abs — —
Density Unit Applied Applied
Base Density Applied Applied
Deviation — —
First Temperature Coef. — —
Second Temperature Coef. — —
Applied : Target parameter is applied by DYFMVTool
*1: Temperature Unit and Pressure Unit in AR Block are not configured by Flow Configuration Wizard Detail
Compensation Mode.
Set manually using Offline Parameter. Refer to section 8.1.1.