Avaya P333T - Manual (Page 104)

Chapter 6 CLI – Layer 2
88 Avaya P333T User’s Guide
Set Commands Summary Table
Following is a Table of the Privileged Level set commands.
• set logout Sets the number of minutes before an
inactive CLI session automatically logs
out. Page 91
• set timezone Sets the timezone for the system. Page 92
• set time protocol Sets the time protocol for use in the
system. Page 92
• set time server Sets the NTP server address. Page 93
• set time client Enables or disables the time client. Page 93
• set ip route Adds IP addresses to the IP routing
table. Page 93
• set snmp community Sets the SNMP community string for a
specific switch. Page 94
• set snmp trap Sets the SNMP trap of the system or
add/delete an entry into/from the
SNMP trap receiver table. Page 94
• set snmp trap auth Enables/disables the SNMP
authentication trap. Page 95
• set snmp retries Sets the number of SNMP retries. Page 95
• set snmp timeout Sets the SNMP timeout. Page 96
• set system location Sets the system location. Page 96
• set system name Sets the system name. Page 96
• set system contact Sets the system contact person. Page 96
• set device-mode Sets the basic mode of operation. Page 97
• set interface Configures the management interface of
the device. Page 97
• set interface ppp Configures the device ppp interface. Page 98
• set port level Sets the priority level of a port. Page 99
• set port negotiation Sets the auto negotiation mode of a port. Page 99
• set port enable Administratively enables a port. Page 100