Reset mgp, Reset wan, Nvram initialize – Avaya P333T User Manual
Page 141: Reset mgp reset wan nvram initialize, Ge 125
Chapter 6
CLI – Layer 2
Avaya P333T User’s Guide
125
reset mgp
Use the
reset mgp
command to perform a software reset in the G700 Media
Gateway Processor.
The syntax for this command is:
reset mgp
reset wan
Use the
reset wan
command to perform a software reset in the X330 WAN Access
Router Module.
The syntax for this command is:
reset wan [module number][bank-a]
Example:
To reset a WAN module residing on switch 2:
P330-N# reset wan 2
This command will force a switch-over to the wan device
and disconnect your telnet session
*** Reset *** - do you want to continue (Y/N)? y
nvram initialize
Use the
nvram initialize
command to reset the P330 parameters to the factory
defaults. If no options are specified for this command, only the Layer 2 parameters
will be reset.
module
number
Optional - the module number where the WAN module to be
reset resides.
bank-a
Optional - boot the WAN module from bank-a after reset.