Avaya P333T - Manual (Page 150)

Chapter 6 CLI – Layer 2
134 Avaya P333T User’s Guide
set radius authentication retry-time
Use the set radius authentication retry-time command to set the time
to wait before re-sending an access request.
The syntax for this command is:
set radius authentication retry time <time>
set radius authentication retry-number
Use the set radius authentication retry-number command to set the
number of times an access request is sent when there is no response.
The syntax for this command is:
set radius authentication retry number <number>
set radius authentication udp-port
Use the set radius authentication udp-port command to set the RFC
2138 approved UDP port number. Normally, the UDP port number should be set to
its default value of 1812. Some early implementations of the RADIUS server used
port number 1645.
The syntax for this command is:
set radius authentication server udp-port <number>
time Retry time in seconds
number Retry number