Avaya P333T - Manual (Page 169)

Appendix A Specifications
Avaya P333T User’s Guide 153
Removing an Existing Expansion Module
1 Loosen the screws by turning the knobs.
2 Grasp the two knobs one near each side of the front panel, and pull gently but
firmly towards yourself.
3 Insert another expansion module or the blanking plate.
Note: The Avaya P330 switch must not be operated with the expansion slot open;
the expansion module should be covered with the supplied blanking plate if
necessary.
Note: X330GT2 Modules are hot swapable and can be inserted or removed in an
operating base unit.
Cabling
A Category 5 copper cable with RJ-45 termination should be used. You should use
all eight wires in the cable.
The maximum copper cable length connected to a 1000Base-T port is 100 m
(328 ft.)