Avaya P333T - Manual (Page 109)

Chapter 6 CLI – Layer 2
Avaya P333T User’s Guide 93
The protocol has been set to TIME protocol
set time server
The set time server command is used to set the TIME server address.
The syntax for this command is:
set time server <ip>
set time client
The set time client command is used to enable or disable the periodic
network time acquisition by the switch from the network time server (SNTP or
TIME protocol).
The syntax for this command is:
set time client <enable|disable>
set ip route
Use the set ip route command to add IP addresses to the IP routing table. You
can configure from one to ten (10) default gateways for a P330 stack.
The syntax for this command is:
set ip route <destination> <gateway>
Output Example:
This example shows how to add a default route to the IP routing table:
P330-N# set ip route 0.0.0.0 192.168.1.1
destination = 0.0.0.0 gateway = 192.168.1.1
ROUTE NET TABLE
destination gateway flags Refcnt Use Interface
------------------------------------------------------------------------
0.0.0.0 192.168.1.1 1 1 3199 se0
127.1.1.0 127.1.1.1 1 8 7606 se1
------------------------------------------------------------------------
ip IP address of the TIME server.
destination IP address of the network, or specific host to be added
gateway IP address of the router