Avaya P333T - Manual (Page 71)

Chapter 6 CLI – Layer 2
Avaya P333T User’s Guide 55
show port blocking
Use the show port blocking command to display the port blocking mode on a
particular switch. Use the session command to change switches before using this
command.
The
show port blocking command is used with the
show self-loop discovery command to confirm a port’s blocking mode.
The syntax for this command is:
show port blocking
Note: This command is not supported by the P330-ML switches.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.