Avaya P333T - Manual (Page 123)

Chapter 6 CLI – Layer 2
Avaya P333T User’s Guide 107
set internal buffering
The set internal buffering command allows you to set the size (either
Maximum or Minimum) of the Receive (Rx) buffer allocated to each port of the
specified switch. This command is meaningless when any port of the switch is
operating with flow control ON.
Note: This command is not supported by P332G-ML and P332GT-ML switches.
The syntax for this command is:
set internal buffering <mod_num> {max|med|min}
Example:
P330-N> set internal buffering 1 max
Done.
set boot bank
Use the set boot bank command to configure the software bank from which the
switch will boot at the next boot process. This command should be issued separately
for each switch in the stack using the
session command.
Note: This command is not supported by the P333R and P333R-LB switches.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
The syntax for this command is:
set boot bank <value>
max Sets the internal receive buffer to its maximum size.
med Sets the internal receive buffer capacity dynamically
min Sets the internal receive buffer to its minimum size (this is the
Default).
value {bank-a | bank-b}