Avaya P333T - Manual (Page 106)

Chapter 6 CLI – Layer 2
90 Avaya P333T User’s Guide
• set port spantree cost Sets the port spantree cost. Page 110
• set port security Enables MAC security on a range of
ports. Page 111
• set cascading Sets switch cascading fault-monitoring
mode. Page 111
• set inband vlan Sets the management VLAN ID. Page 111
• set vlan Creates VLANs. Page 112
• set port flowcontrol Sets the flow control mode of a port. Page 112
• set port auto-
negotiation-
flowcontrol-
advertisement
Sets the flowcontrol advertising
capabilities of a Gigabit port. Page 114
• set trunk Sets the tagging mode of a port. Page 114
• set leaky-vlan Enables/disables leaky-VLAN mode. Page 115
• set spantree Enables/disables Spanning Tree
Protocol (STP). Page 115
• set spantree priority Sets the STP Bridge priority level. Page 115
• set autopartition Enables or disables autopartitioning for
switches in a stack. Page 116
• set license Enters a license number for the stack. Page 116
• set ppp authentication
incoming
Defines the PPP authentication method. Page 117
• set ppp incoming
timeout
Sets the time after which the system
automatically disconnects an idle PPP
incoming session. Page 117
• set ppp baud-rate Sets the baud rate used in PPP sessions. Page 117
• set web
aux-files-url
Sets the location (URL/directory) of the
P330 Device Manager Help files. Page 118
• set intelligent-multicast Enables or disables the IP multicast
filtering application. Page 118
• set intelligent-multicast
client-port-pruning
time
Sets the aging time for client ports. Page 118