Copy module-config tftp, Ge 129 – Avaya P333T User Manual
Page 145
Chapter 6
CLI – Layer 2
Avaya P333T User’s Guide
129
This operation may take a few minutes...
Please refrain from any other operation during this time.
For more information , use 'upload status' command
********************************************************************
* If you are currently running the P330 Device Manager application,*
* it is recommended to exit from it before performing configuration*
* download operations. *
********************************************************************
copy module-config tftp
Use the
copy module-config tftp
command to upload the switch-level
parameters from the current NVRAM running configuration into a file via TFTP.
If an error occurred during upload (you can check this using the command
show
tftp upload status
) you must fix the problem. The following is a list of
possible problems:
a
You did not create an empty text file at the destination server (0 Bytes).
b
You do not have the correct path to the file.
c
The destination server is not active/on.
d
The destination server is unreachable.
Then, perform the upload procedure again twice as follows:
a
Delete the destination file and recreate a correctly named empty file at the
destination server (0 Bytes)
b
Type the command
copy module-config tftp
for the first time.
c
Delete the destination file and recreate a correctly named empty file at the
destination server (0 Bytes)
d
Type the command
copy module-config tftp
again, a second time.
The syntax for this command is:
copy module-config tftp <filename> <ip> <mod_num>
Output Example:
P330-N# copy module-config tftp c:\config\switch1.cfg
192.168.49.10 5
Beginning upload operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
filename
The file name (full path)
ip
The IP address of the TFTP server
mod-num
The switch number