Avaya P333T - Manual (Page 146)

Chapter 6 CLI – Layer 2
130 Avaya P333T User’s Guide
For more information , use 'show tftp upload status' command
********************************************************************
* If you are currently running the P330 Device Manager application,*
* it is recommended to exit from it before performing configuration*
* download operations. *
********************************************************************
copy tftp stack-config
Use the copy tftp stack-config command to download the stack-level
configuration from a saved file into the current NVRAM running configuration, via
TFTP. To use this command, you need to have an active tftp server, and to create a
file into which to download the data. If Avaya Multi-Service Network Manager is
running, an additional TFTP server is not required.
Note: You should perform the nvram initialize command prior to the
copy tftp operation.
The syntax for this command is:
copy tftp stack-config <filename> <ip>
Example:
P330-N# copy tftp stack-config c:\config\switch1.cfg
192.168.49.10
copy tftp module-config
Use the copy tftp module-config command to download the switch-level
configuration from a saved file into the current NVRAM running configuration of a
switch, via TFTP. To use this command, you need to have an active tftp server, and
to create a file into which to download the data. If Avaya Multi-Service Network
Manager is running, an additional tftp server is not required.
Note: You should perform the nvram initialize command prior to the
copy tftp operation.
filename The file name (full path)
ip The IP address of the TFTP server