Avaya P333T - Manual (Page 43)

Chapter 4 Installation and Setup
Avaya P333T User’s Guide 27
Note: Functions operate in their default settings unless configured otherwise.
Table 4.2 Default Port Settings
Function Default Setting
10/100Base-TX ports 100Base-F ports 1000 Base-X ports
Duplex mode Full duplex Full duplex Full duplex only
Port Speed 100M 100M 1000M
Flow control Off Off Off
Flow control
advertisement Off N/A Off (No pause)
Backpressure On (only in Half duplex) Not Applicable Not Applicable
Autopartitioning Disabled (only in Half
duplex) N/A N/A
Auto-negotiation Enable Not Applicable Enable
1
1 Ensure that the other side is also set to Autonegotiation Enabled
Administration status Enable Enable Enable
Port VLAN 1 1 1
Tagging mode Clear Clear Clear
Port priority 0 0 0
Spanning Tree cost 20 20 4
Spanning Tree port
priority 128 128 128