Avaya P333T - Manual (Page 118)

Chapter 6 CLI – Layer 2
102 Avaya P333T User’s Guide
set port name
Use the set port name to configure a name for a port. If you do not specify a
name, the port name remains empty.
The syntax for this command is:
set port name <mod_num>/<port_num> [<name>]
Output Example:
P330-N# set port name 1/2 arthur
Port 1/2 name set.
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
set port trap
Use the set port trap command to enable/disable generic SNMP uplink/
downlink traps from a port.
The syntax for this command is:
set port trap <mod_num>/<port_num> {enable|disable}
Output Example:
P330-N# set port trap 1/2 enable
Port 1/2 up/down trap enabled.
set port vlan
Use the set port vlan command to set the Port’s VLAN ID (PVID). The VLAN
number must be within the range 1 to 3071.
The syntax for this command is:
set port vlan <value> <mod_num>/<port_num>
name Name assigned to the port.
value Number between 1 and 3071, identifying the VLAN.
mod_num/
port_num The switch number/the port number.