Avaya P333T - Manual (Page 124)

Chapter 6 CLI – Layer 2
108 Avaya P333T User’s Guide
Output Example:
P330-1(super)# set boot bank bank-a
Boot bank set to bank-a
set intermodule port redundancy
Use the set intermodule port redundancy command to define or delete the
stack’s unique intermodule redundancy scheme. The defined scheme can be cleared
using the
set intermodule port redundancy off command .
The syntax for this command is:
set intermodule port redundancy <module/prim-port> <module/
second-port> {on [<name>]}
Output Example:
P330-N> set intermodule port redundancy 1/7 2/12 on backbone
backbone: port 2/12 is intermodule redundant to port 1/7
Note: You must disable Spanning Tree before you can enable redundancy.
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
set intermodule port redundancy off
Use the set intermodule port redundancy off command to clear the
intermodule redundancy scheme.
The syntax for this command is:
set intermodule port redundancy off
module/prim-port The primary port number
module/second-port The secondary port number
on Set the intermodule redundancy
name The name of the fast redundancy (default is 'fast')