Avaya P333T - Manual (Page 107)

Chapter 6 CLI – Layer 2
Avaya P333T User’s Guide 91
set logout
The set logout command is used to set the number of minutes until the system
automatically disconnects an idle session.
The syntax for this command is:
set logout <timeout>
Output Example:
To set the number of minutes until the system disconnects an idle session
• set intelligent-multicast
router-port-pruning
time
Sets the aging time for router ports. Page 119
• set intelligent-multicast
group-filtering-delay
time
Sets the time delay before a filter is
applied to a specific group. Page 119
• set secure mac Adds a unicast MAC address into the
CAM table of a secured port. Page 119
• set security mode Enables or disables the stack’s MAC
security. Page 120
• set arp-aging-interval Sets the ARP aging interval. Page 120
• set arp-tx-interval Sets the keep-alive interval. Page 120
• set self-loop-discovery
Admin_Status
Sets the IBM token ring discovery mode. Page 121
• set welcome message Sets a welcome message to appear after
a reboot. Page 121
• set allowed managers
enabled/disabled
Enables/disables the Allowed Managers
feature. Page 122
• set allowed managers
IP
Used to add or remove an IP address
from the allowed managers table. Page 122
• set psu type Sets the main power supply type (AC/
DC) of the module. Page 122
timeout Number of minutes (0 to 999) until the system automatically
disconnects an idle session. Setting the value to 0 disables the
automatic disconnection of idle sessions (default is 15 minutes).