Avaya P333T - Manual (Page 138)

Chapter 6 CLI – Layer 2
122 Avaya P333T User’s Guide
Note: If you wish to define a string which includes spaces, you must enclose the
entire string in quotation marks, e.g. "new york".
set allowed managers
Use the set allowed managers command toenable/disable the Allowed
Managers feature. When this feature is enabled, only those stations whose IP
addresses are listed in the Allowed Managers table can access the device over
Telnet, SNMP, or HTTP.
The syntax for this command is:
set allowed managers [enabled|disabled]
Output Example:
P330-N> set allowed managers enabled
Managers are enabled
set allowed managers IP
Use the set allowed managers IP command to add or remove an IP address
from the Allowed Managers table. The Allowed Managers table can contain up to
twenty IP addresses.
The syntax for this command is:
set allowed managers ip [add|delete][IP address]
Output Example:
P330-N> P330-1(super)# set allowed managers ip add
149.49.32.134
Ip was added to the table
set psu type
Use the set psu type command to set the main power supply type (AC/DC) of
the module.
Note: This command is not applicable to P332G-ML and P332GT-ML switches. This
command is used to set the power supply types for other P330 switches in the stack.