HP Integrated Lights-Out 4 - Manual (Page 140)

Figure 68 Advanced Network Options screen
5. View or update the following values, as needed:
•
Gateway from DHCP—Specifies whether iLO uses a DHCP server-supplied gateway.
•
Gateway #1, Gateway #2, and Gateway #3—If Gateway from DHCP is disabled, enter
up to three iLO gateway IP addresses.
•
DHCP Routes—Specifies whether iLO uses the DHCP server-supplied static routes.
•
Route 1, Route 2, and Route 3—If DCHP Routes is disabled, enter the iLO static route
destination, mask, and gateway addresses.
•
DNS from DHCP—Specifies whether iLO uses the DHCP server-supplied DNS server list.
•
DNS Server 1, DNS Server 2, DNS Server 3—If DNS from DHCP is disabled, enter the
primary, secondary, and tertiary DNS servers.
•
WINS from DHCP—Specifies whether iLO uses the DHCP server-supplied WINS server
list.
•
Register with WINS Server—Specifies whether iLO registers its name with a WINS server.
•
WINS Server #1 and WINS Server #2—If WINS from DHCP is disabled, enter the primary
and secondary WINS servers.
•
Domain Name—The iLO domain name. If DHCP is not used, enter a domain name.
6. Press F10 to save the changes.
7. Press Esc until the main menu is displayed.
8. Select Exit and Resume Boot in the main menu, and then press Enter.
9. When prompted to confirm the request, press Enter to exit the utility and resume the normal
boot process.
Configuring access settings by using the iLO 4 Configuration Utility
You can use the iLO 4 Configuration Utility Setting Options menu to configure iLO access settings.
To configure iLO access settings:
140 Configuring iLO