HP Integrated Lights-Out 4 - Manual (Page 179)

Where:
•
<iLO IP address> is the iLO IP address.
•
from=<yyyy-mm-dd>&to=<yyyy-mm-dd> represents the start and end date of the
range of dates to include in the log. Enter dates in the format year-month-day, for
example, 2013-07-29 for July 29, 2013.
•
–k specifies that HTTPS warnings will be ignored.
•
–v specifies verbose output.
•
-u <username>:<password> specifies your iLO user account credentials.
•
–o <filename> specifies the output file name and path.
NOTE: To download the entire log, omit the from and to parameters and use the following
command: curl "https://<iLO IP address>/ahsdata/ahs.ahs" -k -v -u
<username>:<password> -o <filename>.ahs
The file is saved to the path you specified.
4. Close the command window.
Clearing the Active Health System log
If the log file is corrupted, or if you want to clear and restart logging, use the following procedure
to clear the Active Health System log. You must have the Configure iLO Settings privilege to perform
this procedure.
1.
Navigate to the Information
→Active Health System log page, as shown in
Figure 88 (page 177) .
2. Click Show Advanced Settings.
3. Scroll to the Clear the Active Health System Log section, and then click the Clear button.
The following message appears:
Are you sure that you want to clear the entire Active Health System
log?
4. Click OK.
The following message appears at the top of the page:
The AHS Log is being cleared and it may take several minutes. Note:
You must reset iLO after clearing the Active Health System log. Some
Active Health System data is recorded to the log only during iLO
startup. Resetting iLO ensures that a complete set of data is
available in the log.
5. Reset iLO.
For instructions, see “Using iLO diagnostics” (page 179) .
Resetting iLO after clearing the Active Health System log is required because some Active
Health System data is recorded to the log only during iLO startup. Performing this step ensures
that a complete set of data is available in the log.
Using iLO diagnostics
The Diagnostics page displays iLO self-test results and allows you to reset iLO, generate an NMI
to the system, or configure redundant ROM.
To view iLO diagnostics information, navigate to the Information
→Diagnostics page, as shown in
Figure 89 (page 180) .
Using iLO diagnostics 179