HP Integrated Lights-Out 4 - Manual (Page 303)

iLO management port not accessible by name
Solution: The iLO management port can register with a WINS server or DDNS server to provide
the name-to-IP-address resolution required to access the iLO management port by name. The WINS
or DDNS server must be up and running before the iLO management port is powered on, and the
iLO management port must have a valid route to the WINS or DDNS server.
In addition, the iLO management port must be configured with the IP address of the WINS or
DDNS server. You can use DHCP to configure the DHCP server with the required IP addresses.
These options are enabled as factory defaults and can be changed by using the iLO RBSU, the
iLO 4 Configuration Utility, or iLO web interface. For more information, see
“Setting up iLO by
using iLO RBSU or the iLO 4 Configuration Utility” (page 20) or “Configuring iLO network settings”
(page 88) .
The clients that are used to access the iLO management port must be configured to use the same
DDNS server where the IP address of the iLO management port is registered.
If you are using a WINS server and a nondynamic DNS server, access to the iLO management
port might be significantly faster if you configure the DNS server to use the WINS server for name
resolution. For more information, see the appropriate Microsoft documentation.
iLO RBSU unavailable after iLO and server reset
Solution: Reset the server a second time. To avoid this issue, after resetting the processor, wait a
few seconds before resetting the server.
If the iLO processor is reset and the server is immediately reset, iLO firmware might not be fully
initialized when the server performs its initialization and attempts to start the iLO RBSU. In this
case, the iLO RBSU is unavailable, or the iLO option ROM code is skipped altogether.
Unable to access the login page
Solution: Verify that the SSL encryption level of your browser is set to 128 bits. The SSL encryption
level in iLO is set to 128 bits and cannot be changed. The browser and iLO encryption levels must
be the same.
Secure Connection Failed error when using Firefox browser
When you try to connect to iLO using Firefox ESR, the following message appears ( Figure 167 ).
Figure 167 Secure Connection Failed dialog box
Solution 1:
Login issues 303