HP Integrated Lights-Out 4 - Manual (Page 91)

The IPv6 Summary section displays the following information:
•
DHCPv6 Status—Indicates whether DHCP is enabled for IPv6. The following values are possible:
Enabled—Stateless and Stateful DHCPv6 are enabled. ◦
◦ Enabled (Stateless)—Only Stateless DHCPv6 is enabled.
◦ Disabled—DHCPv6 is disabled.
•
IPv6 Stateless Address Auto-Configuration (SLAAC)—Indicates whether SLAAC is enabled for
IPv6. When SLAAC is disabled, the SLAAC link-local address for iLO is still configured because
it is required.
•
Address list—This table shows the currently configured IPv6 addresses for iLO. It provides the
following information:
◦ Source—Indicates whether the address is a static or SLAAC address.
◦ IPv6—The IPv6 address.
◦ Prefix Length—The address prefix length.
◦ Status—The address status: Active (the address is in use by iLO), Pending (Duplicate
Address Detection is in progress for this address), or Failed (Duplicate Address Detection
failed and the address is not in use by iLO).
•
Default Gateway—The default IPv6 gateway address that is currently in use. For IPv6, iLO
keeps a list of possible default gateway addresses. The addresses in this list originate from
router advertisement messages and the IPv6 Static Default Gateway setting.
The Static Default Gateway setting is configured on the IPv6 page. For more information, see
“Configuring IPv6 settings” (page 96) .
Configuring general network settings
Use the iLO Dedicated Network Port or Shared Network Port Network General Settings page to
configure general network settings. You must have the Configure iLO Settings privilege to make
changes on this page.
1.
Navigate to the Network
→iLO Dedicated Network Port or Network→Shared Network Port
page.
2. Click the General tab, as shown in Figure 41 (page 92) .
Configuring iLO network settings 91