HP Integrated Lights-Out 4 - Manual (Page 96)

◦ Use DHCPv4 Supplied Time Settings—Specifies whether iLO uses the DHCPv4-supplied
NTP service locations.
◦ Use DHCPv4 Supplied WINS Servers—Specifies whether iLO uses the DHCP
server-supplied WINS server list. If not, enter the WINS server addresses in the
Primary WINS Server and Secondary WINS Server boxes.
•
IPv4 Address—The iLO IP address. If DHCP is used, the iLO IP address is supplied
automatically. If DHCP is not used, enter a static IP address.
•
Subnet Mask—The subnet mask of the iLO IP network. If DHCP is used, the subnet mask
is supplied automatically. If DHCP is not used, enter a subnet mask for the network.
•
Gateway IPv4 Address—The iLO gateway IP address. If DHCP is used, the iLO gateway
IP address is supplied automatically. If DHCP is not used, enter the iLO gateway IP address.
•
Static Route #1, Static Route #2, and Static Route #3—The iLO static route destination,
mask, and gateway addresses. If Use DHCPv4 Supplied Static Routes is used, these values
are supplied automatically. If not, enter the static route values.
•
DNS server information—Enter the following information:
Primary DNS Server—If Use DHCPv4 Supplied DNS Servers is enabled, this value is
supplied automatically. If not, enter the Primary DNS Server address. ◦
◦ Secondary DNS Server—If Use DHCPv4 Supplied DNS Servers is enabled, this value
is supplied automatically. If not, enter the Secondary DNS Server address.
◦ Tertiary DNS Server—If Use DHCPv4 Supplied DNS Servers is enabled, this value is
supplied automatically. If not, enter the Tertiary DNS Server address.
◦ Enable DDNS Server Registration—Select or clear this check box to specify whether
iLO registers its IPv4 address and name with a DNS server.
•
WINS server information—Enter the following information:
Primary WINS Server—If Use DHCPv4 Supplied WINS Servers is enabled, this value
is supplied automatically. If not, enter the Primary WINS Server address. ◦
◦ Secondary WINS Server—If Use DHCPv4 Supplied WINS Servers is enabled, this
value is supplied automatically. If not, enter the Secondary WINS Server address.
◦ Enable WINS Server Registration—Specifies whether iLO registers its name with a
WINS server.
•
Ping Gateway on Startup—Causes iLO to send four ICMP echo request packets to the
gateway when iLO initializes. This ensures that the ARP cache entry for iLO is up-to-date
on the router responsible for routing packets to and from iLO.
4. Click Submit to save the changes you made on the IPv4 Settings page.
5. If you are finished configuring the iLO network settings on the General, IPv4, IPv6, and SNTP
tabs, click Reset to restart iLO.
It might take several minutes before you can re-establish a connection.
Configuring IPv6 settings
Use the iLO Dedicated Network Port IPv6 Settings page to configure IPv6 settings for iLO. You
must have the Configure iLO Settings privilege to make changes on this page.
96 Configuring iLO