HP Integrated Lights-Out 4 User Manual
Page 326
5.
Select YES, and then press Enter.
The iLO 4 Configuration Utility prompts you to confirm the reset request, as shown in
Figure 177 Set to factory defaults confirmation screen
The iLO system is reset, and you cannot access the iLO 4 Configuration Utility until after the
next system reboot.
You can press Enter to confirm, or press Esc to cancel.
6.
Press Enter.
iLO resets to the factory default settings. If you are managing iLO remotely, the remote console
session is automatically ended.
7.
Resume the boot process:
a.
Optional: If you are managing iLO remotely, wait for the iLO reset to finish, and then
start the iLO remote console.
The iLO 4 Configuration Utility screen is still open from the previous session.
b.
Press Esc until the main menu is displayed.
c.
Select Exit and Resume Boot in the main menu, and then press Enter.
d.
When prompted to confirm the request, press Enter to exit the screen and resume the
boot process.
NOTE:
If a server has an installed iLO Advanced license when you perform this procedure, the
iLO Advanced icon might be selected when the server boot process finishes. The icon will be set
correctly after POST completes, or after the server is shut down, powered off, and then powered
on again.
Server name still present after System Erase Utility is executed
The server name, as shown on the iLO Overview page, is the installed host operating system name.
If the Insight Management Agents are installed on the server, the agents will obtain the host name
and update it on the iLO web interface page.
326 Troubleshooting