HP Integrated Lights-Out 4 - Manual (Page 81)

Configuring iLO for HP SSO
1. Navigate to the Administration
→Security→HP SSO page, as shown in
Figure 35 (page 81) .
Figure 35 Security–Single Sign-On Settings page
2. Make sure you have an iLO license key installed.
3. Enable Single Sign-On Trust Mode by selecting Trust by Certificate, Trust by Name, or Trust
All.
The iLO firmware supports configurable trust modes, which enables you to meet your security
requirements. The trust mode affects how iLO responds to HP SSO requests. If you enable
support for HP SSO, HP recommends using the Trust by Certificate mode. The available modes
follow:
•
Trust None (SSO disabled) (default)—Rejects all SSO connection requests
•
Trust by Certificate (most secure)—Enables SSO connections from an HP SSO-compliant
application by matching a certificate previously imported to iLO
•
Trust by Name—Enables SSO connections from an HP SSO-compliant application by
matching an IP address or DNS name imported directly, or an IP address or DNS name
included in a certificate imported to iLO
•
Trust All (least secure)—Accepts any SSO connection initiated from any HP SSO-compliant
application.
Configuring iLO security 81