HP Integrated Lights-Out 4 User Manual
Page 327
To remove the server name after the redeployment of a server, do one of the following:
•
Load the HP Insight Management Agents to update the server name.
•
Use the iLO RBSU or the iLO 4 Configuration Utility Reset to Factory Defaults feature to clear
the server name.
CAUTION:
This procedure clears all iLO configuration information, not just the Server Name
information.
•
Change the server name on the Administration
→Access Settings→Access Options page in the
iLO web interface.
Certificate error when navigating to iLO web interface
Issue: When you point your browser to the iLO web interface, a certificate error appears.
Suggested action: Use one of the following procedures to resolve the error.
Resolving a browser certificate error: Internet Explorer
1.
Click the Continue to this website (not recommended) link, as shown in
Figure 178 Internet Explorer security certificate warning
2.
Log in to the iLO web interface.
3.
Navigate to the Administration
→Security→SSL Certificate page.
4.
Click Customize Certificate.
5.
Enter the following information in the Certificate Signing Request (CSR) Information section.
The required boxes are marked with an asterisk (*) in the GUI.
•
Country (C)—The two-character country code that identifies the country where the company
or organization that owns this iLO subsystem is located
•
State (ST)—The state where the company or organization that owns this iLO subsystem is
located
•
City or Locality (L)—The city or locality where the company or organization that owns this
iLO subsystem is located
•
Organization Name (O)—The name of the company or organization that owns this iLO
subsystem
Troubleshooting miscellaneous issues 327