HP Integrated Lights-Out 4 - Manual (Page 94)

•
Select or clear the Enable VLAN check box to enable or disable VLAN (Shared Network
Port only).
When the Shared Network Port is active and VLAN is enabled, the iLO Shared Network
Port becomes part of a VLAN. All network devices with different VLAN tags will appear
to be on separate LANs, even if they are physically connected to the same LAN.
•
If you enabled VLAN, enter a VLAN Tag (Shared Network Port only). All network devices
that you want to communicate with each other must have the same VLAN tag. The VLAN
tag can be any number between 1 and 4094.
5. Click Submit to save the changes.
6. If you are finished configuring the iLO network settings on the General, IPv4, IPv6, and SNTP
tabs, click Reset to restart iLO.
It might take several minutes before you can re-establish a connection.
Configuring IPv4 settings
Use the iLO Dedicated Network Port or Shared Network Port IPv4 Settings page to configure IPv4
settings for iLO. You must have the Configure iLO Settings privilege to make changes on this page.
1.
Navigate to the Network
→iLO Dedicated Network Port or Network→Shared Network Port
page.
2. Click the IPv4 tab, as shown in Figure 42 (page 95) .
94 Configuring iLO