HP Integrated Lights-Out 4 - Manual (Page 22)

5. Enter an IP address and subnet mask:
a.
Select Network
→NIC and TCP/IP, and then press Enter.
The Network Configuration window opens.
b. Enter the appropriate information in the IP Address, Subnet Mask, and Gateway IP Address
fields, as shown in
Figure 4 (page 22) .
Figure 4 iLO RBSU Network Configuration window
c. Press F10 to save the changes.
6. Select File
→Exit to exit iLO RBSU.
The changes take effect when you exit iLO RBSU.
Configuring a static IP address by using the iLO 4 Configuration Utility
This procedure is required only if you are using a static IP address. When you are using dynamic
IP addressing, your DHCP server automatically assigns an IP address for iLO.
NOTE: To simplify installation, HP recommends using DNS or DHCP with iLO.
To configure a static IP address:
1.
Optional: If you access the server remotely, start an iLO remote console session.
You can use the .NET IRC or Java IRC.
2. Restart or power on the server.
3. Press F9 in the HP ProLiant POST screen.
The System Configuration screen appears.
4. Use the up or down arrow keys and the Enter key to navigate to the System Configuration
→iLO
Configuration Utility
→Network Options screen.
The System Configuration screen displays the Network Options, as shown in Figure 5 (page
23) .
22 Setting up iLO