HP Integrated Lights-Out 4 - Manual (Page 168)

The following status information is displayed for controllers that support encryption:
•
Encryption Status—The following values are possible:
Enabled ◦
◦ Not Enabled
◦ Enabled—Local Mode—This value is displayed when you do not use a remote key
management server.
•
Encryption ASIC Status—Indicates whether the ASIC encryption self tests for the controller
passed or failed. A failed status indicates that the controller is not encrypted.
•
Encryption Critical Security Parameter NVRAM Status—Indicates whether the controller
successfully detected the critical security parameter NVRAM. A failed status means that the
controller is not encrypted.
NOTE: The encryption settings for an HP Smart Array controller can be configured by using the
HP Smart Storage Administrator software. For instructions, see the HP Smart Storage Administrator
documentation.
Drive Enclosures
This section provides the following information about the drive enclosures attached to an HP Smart
Array controller:
•
Enclosure port and box numbers
•
Enclosure status
•
Number of drive bays
•
Serial number
•
Model number
•
Firmware version
Some enclosures do not have all of the listed properties, and some storage configurations do not
have drive enclosures.
Logical Drives
This section is available when the Logical View option is selected on the System Information –
Storage Information page. The following information is listed for the logical drives attached to an
HP Smart Array controller:
•
Logical drive number
•
Logical drive status
•
Logical drive capacity
•
Fault tolerance
•
Encryption status
NOTE: Logical drives must be configured through the HP Smart Storage Administrator software
before they can be displayed on the System Information – Storage Information page. For more
information, see the HP Smart Storage Administrator documentation.
Physical Drives
The information listed in this section depends on whether the Logical View or Physical View option
is selected. When using Logical View, physical drives that are configured as part of an array are
listed. When using Physical View, all physical drives are listed.
168 Using iLO