HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 108)

1 Media length adjustment
2 Media width adjustment
3 Page length (Y dimension)
4 Page width (X dimension)
Use the following procedure to configure a tray for a custom size. Once a custom size is set for a tray,
it will be retained until the media length guides are reset.
To set a custom size in Tray 2, 3, or 4
1. Open the tray and place the media in the tray.
2. Set the media length and width guides to the appropriate non-standard position and close the tray.
3. Press Menu .
4. Touch PAPER HANDLING .
5. Touch TRAY <N> SIZE (where N is the number of the tray).
6. Scroll to and touch CUSTOM .
7. Touch X.XxX.X INCHES or X MILLIMETERS . This selects the measurement units for determining
the size of your custom paper.
8. Use the numeric keypad or the scroll bar to set the X dimension (the short edge of the paper). The
X dimension can range from 148 to 216 mm (5.83 to 8.5 inches).
9. Use the numeric keypad to set the Y dimension (the long edge of the paper). The Y dimension can
range from 210 to 356 mm (8.27 to 14 inches).
10. Touch OK .
11. Touch EXIT .
88 Chapter 4 Printing tasks ENWW