HP Color LaserJet 4730 Multifunction Printer series User Manual
Page 280
Control panel message
Description
Recommended action
EIO X disk
initializing
The EIO disk device in slot X is initializing.
No action necessary.
EIO X disk
spinning up
The EIO disk device in slot X is spinning up
its platter.
No action necessary.
Error executing Digital Send job. Job
failed.
A digital send job has failed and cannot be
delivered.
Try to send the job again.
Event Log Empty
SHOW EVENT LOG was selected from the
control panel, and the event log is empty.
No action necessary.
FLASH DEVICE
FAILURE
To clear touch "OK".
alternates with
Ready
A device failure has occurred on the specified
drive. Printing can continue for jobs that do
not require the Flash DIMM.
1.
To clear the message, touch
OK
.
2.
If the message persists, remove and re-
install the EIO disk drive.
3.
Turn the MFP back on.
4.
If the message still persists, replace the
Flash DIMM.
FLASH FILE
SYSTEM IS FULL
To clear touch "OK".
alternates with
Ready
The MFP received a PJL file system
command that attempted to store something
on the file system but was unsuccessful
because the file system is full.
1.
Use HP Web Jetadmin software to
delete files from the Flash Memory and
try again.
2.
To clear the message, touch
OK
.
3.
If the message persists, turn the MFP off
then on.
FLASH IS
WRITE PROTECTED
To clear touch "OK".
alternates with
Ready
The file system device is protected and no
new files can be written to it.
1.
To enable writing to the Flash Memory,
turn off write protection, using HP Web
Jetadmin.
2.
To clear the message, touch
OK
.
3.
If the message persists, turn the MFP off
then on.
Front Side Optical System Error
The scanner has experienced an error.
To temporarily clear the message so you can
send a fax or send to e-mail, touch
IGNORE
. If this message persists, contact an
HP-authorized service or support provider.
See the HP support flyer, or go to
Genuine HP supplies installed
A new HP cartridge has been installed. The
MFP returns to the Ready state after
approximately 10 seconds.
No action necessary.
HP Digital Sending: Delivery Error
A digital send job has failed and cannot be
delivered.
Try to send the job again.
Incorrect PIN
The wrong PIN was entered. After three
incorrect PIN entries, the MFP will return to
Ready.
Re-enter PIN correctly.
260
Chapter 12 Solving problems
ENWW