HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 291)

Control panel message Description Recommended action
REPLACE SUPPLIES
To continue touch "OK".
The supplies gauge will display the
consumption levels of print cartridges.
Multiple supplies are at the end of their useful
life and the REPLACE SUPPLIES setting in
the SYSTEM SETUP menu is set to STOP
AT LOW.
1. Touch SUPPLIES STATUS menu.
2. Scroll to the specific supply that has a
problem.
3. Touch to view help for the supply.
4. Use the scroll bar to step through the
instructions.
5. Supplies ordering information is also
available from the embedded Web
server. See
Using the
embedded Web server for more
information.
REPLACE SUPPLIES
Using black only
Press Status
alternates with
<Current status message>
AUTOCONTINUE BLACK is set in the
COLOR SUPPLY OUT menu and a color
print cartridge is Out. Printing can continue in
black only. Replace the indicated print cartridge.
REPLACE TRANSFER KIT
For help press
The transfer unit is at end of life. Printing can
continue but print quality might be reduced. 1. Open the top and side covers.
2. Lower the transfer unit by pulling the
green handle at the top of the unit
downward.
3. Depress the small blue latches located
on either side of the bottom of the
transfer unit and lift the unit out of the
MFP.
4. Install the new transfer unit.
5. Close the front and top covers.
6. Supplies ordering information is also
available from the embedded Web
server. See
Using the
embedded Web server for more
information.
REPLACE TRANSFER KIT
For help press
alternates with
REPLACE TRANSFER KIT
To continue touch "OK".
The transfer unit is nearing the end of its
useful life and the REPLACE SUPPLIES
setting in the SYSTEM SETUP menu is set to
STOP AT LOW. 1. Order the transfer kit.
2. To continue printing, touch OK .
3. To replace the transfer kit, perform the
following steps:
● Open the top and side covers.
● Lower the transfer unit by pulling
the green handle at the top of the
unit downward.
● Depress the small blue latches
located on either side of the bottom
of the transfer unit and lift the unit
out of the MFP.
ENWW Control panel messages 271