HP Color LaserJet 4730 Multifunction Printer series User Manual
Page 277
Control panel message
Description
Recommended action
ADF Pick Error
The ADF experienced an error while picking
paper.
Make sure that your original contains no more
than 30 pages. Follow the instructions in the
onscreen dialog box.
ADF Skew Error
Paper is skewed in the ADF.
Make sure that the paper guides are aligned
on the sides of the originals, and that all of the
originals are the same size. Remove the
remaining paper from the ADF and close the
ADF cover. Follow the instructions in the
onscreen dialog box.
Attachment Too Big
The scanned documents have exceeded the
size limit of the server.
Send the job again using a lower resolution,
smaller file size settings, or fewer pages. See
to learn
how to reduce the size of the attachment.
Contact the network administrator to enable
sending the scanned documents by using
multiple e-mails.
BAD DUPLEXER
CONNECTION
alternates with
For help press
The duplexer is not connected properly and
must be reinserted before printing can
continue.
Turn the MFP off.
Use the scroll bar to step through the
instructions.
If the error does not clear, record the
message and contact HP Support at
.
BAD OPTIONAL TRAY
CONNECTION
The 500-sheet input tray is not making proper
connection with the MFP.
1.
Verify that the MFP is on a level surface.
2.
Turn the MFP off.
3.
Reseat the MFP on the 500-sheet input
tray.
4.
Turn the MFP on after reseating the
500-sheet input tray.
Calibrating...
The MFP is calibrating.
No action necessary.
Canceling... X
The MFP is in the process of canceling a job.
The message will continue to be displayed
while the job is stopped, the paper path
flushed, and any remaining incoming data on
the active data channel is received and
discarded.
No action necessary.
CARD SLOT X NOT
FUNCTIONAL
The flash card in slot X is not working
correctly.
1.
Turn the MFP off.
2.
Remove the card from the slot indicated
and replace with a new card.
Check Cables
The cable that connects the scanner to the
MFP is experiencing an error.
Make sure that the cable between the
scanner and the MFP is connected. Turn the
MFP off then on. If the error persists, replace
the cable. If the error still persists, contact an
HP-authorized service or support provider.
See the HP support flyer, or go to
Check Cables Check Scanner
The scanner might be locked or the interface
cable might be seated incorrectly.
Make sure the scanner is unlocked and the
interface cable is seated correctly.
Check Output Device
An error has occurred with the output device. Remove and reinstall the ouptut device.
Observe the LED on the device. If it is flashing
ENWW
Control panel messages
257