HP Color LaserJet 4730 Multifunction Printer series User Manual
Page 292
Control panel message
Description
Recommended action
●
Install the new transfer unit.
●
Close the front and top covers.
●
Supplies ordering information is
also available from the embedded
Web server. See
for more
information.
Request accepted
please wait
The MFP has accepted a request to print an
internal page, but the current job must finish
printing before the internal page will print.
No action necessary.
Resend
upgrade
The firmware upgrade was not completed
successfully.
Attempt upgrade again.
Restoring...
[accessory #]
The MFP is restoring external accessory
settings in response to a user request.
No action necessary.
Restoring...
The MFP is restoring settings. This message
is displayed during the execution of a restore
action, such as RESTORE COLOR
VALUES.
No action necessary.
Restoring...
factory settings
The MFP is restoring factory settings.
No action necessary.
Rotating <COLOR>
motor
To exit press
Stop
A component test is in progress; the
component selected is the <color> cartridge
motor.
Press
Stop
when ready to stop this test.
Rotating motor
To exit press
Stop
The MFP is executing a component test and
the component selected is a motor.
Press
Stop
when ready to stop this test.
SANITIZING DISK X% COMPLETE
DO NOT POWER OFF
A storage device is being sanitized. Do not
turn the MFP off. When the process is
complete, the MFP will automatically restart.
No action necessary.
SCAN CARRIAGE LOCKED Check lock
switch, cycle power.
The flatbed scanner carriage is locked for
shipping.
Turn off the MFP, unlock the scanner
carriage, and turn on the MFP.
Scan Failure Press "START" to rescan
The scan was unsuccessful and the
document needs to be rescanned.
If necessary, reposition the document to
rescan it, and then press
Start
.
Setting saved
A menu selection has been saved.
No action necessary.
SIZE MISMATCH
TRAY X=paperShort
For help press
alternates with
Ready
The tray is loaded with paper that is longer or
shorter in the feed direction than the size
configured for the tray.
1.
Adjust the side and rear media guides
against the paper.
2.
If necessary, touch
OK
after the tray is
closed to change the paper size or type
configuration to match the size or type
of paper loaded in the tray.
Sleep mode on
The MFP is in sleep mode. A button press,
receipt of printable data, or an error condition
will clear this message.
No action necessary.
272
Chapter 12 Solving problems
ENWW