HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 287)

Control panel message Description Recommended action
Printing...
FONT LIST
The MFP is generating either the PCL or PS
personality typeface list. The MFP will return
to the Ready state when the page is
completed. No action necessary.
Printing...
MENU MAP
The MFP is generating the MFP menu map.
The MFP will return to the Ready state when
the page is completed. No action necessary.
Printing...
PQ TROUBLESHOOTING
The MFP is generating the print quality
troubleshooting pages. The MFP will return to
the Ready state when the pages are printed. Follow the instructions on the printed pages.
Printing...
REGISTRATION PAGE
The MFP is generating the registration page.
The MFP will return to the SET
REGISTRATION menu when the page is
completed. Follow the instructions on the printed pages.
Printing...
RGB Samples
This message displays while the MFP RGB
samples page is being generated. No action necessary.
Printing...
SUPPLIES STATUS
The MFP is generating the supplies status
page. The MFP will return to the online
Ready state when the page is completed. No action necessary.
Printing...
Usage Page
The MFP is generating the usage page. The
MFP will return to the online Ready state
when the page is completed. No action necessary.
Processing duplex
job
Do not grab paper
until job completes
Paper temporarily comes into the output bin
while printing a duplex job. Do not attempt to
remove the pages until the job is complete. Do not grab paper as it temporarily comes
into the output bin. The message will
disappear when the job is finished.
Processing... The MFP is currently processing a job but is
not yet picking pages. When paper motion
begins, this message will be replaced by a
message that indicates which tray the job is
being printed from. No action necessary.
Processing...
copy <X> of <Y>
The MFP is currently processing or printing
collated copies. The message indicates that
copy X of Y total copies is currently being
processed. No action necessary.
Processing...
from tray xx
The MFP is actively processing a job from the
designated tray. No action necessary.
Processing...
INTERMITTENT MODE
For help press
This message might be displayed during
periods of heavy usage if the MFP becomes
overheated. If this occurs, the MFP enters a
mode in which it prints for one minute and
pauses for one minute. This cycle continues
until the operating temperature stabilizes. Use the scroll bar to step through the
instructions.
RAM DISK
SYSTEM IS FULL
To clear touch "OK".
The MFP received a PJL file system
command that attempted to store something
on the file system but was unsuccessful
because the file system is full. ● To clear the message, touch OK .
● If the message persists, turn the MFP off
then on.
ENWW Control panel messages 267