HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 28)

Security features
● Foreign Interface Harness (FIH)
● Secure Disk Erase
● Security lock
● Job retention
● DSS authentication
Minimum system requirements
To use the e-mail functionality, the MFP must be connected to an IP-based network that has a
simple mail transfer protocol (SMTP) server. This server can either be on the local area network
or at an outside Internet service provider (ISP). HP recommends that the MFP be located on the
same local area network (LAN) as the SMTP server. If you are using an ISP, you must connect to
the ISP by using a digital subscriber line (DSL) connection. If you are obtaining e-mail services
from an ISP, ask the ISP to provide the correct SMTP address. Dial-up connections are not
supported. If you do not have an SMTP server on your network, third-party software is available
that allows you to create an SMTP server. However, purchase and support of this software is your
responsibility.
8 Chapter 1 MFP basics ENWW