HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 74)

Item Values Explanation
PS Normally you should not change the
product language (the default is AUTO).
If you change the setting to a specific
product language, the MFP does not
automatically switch from one language
to another unless specific software
commands are sent to the MFP.
CLEARABLE WARNINGS JOB*
ON
Set the amount of time that a clearable
warning appears on the MFP control
panel.
JOB: Warning messages appear on the
control panel until the end of the job from
which they were generated.
ON: Warning messages appear on the
control panel until they are cleared.
AUTO CONTINUE OFF
ON*
This item determines how the MFP
reacts to errors.
OFF: If an error prevents printing, the
message remains on the display, and the
MFP does not print until you touch
CONTINUE .
ON: If an error prevents printing, the
message is displayed, and the MFP goes
offline for 10 seconds before returning
online.
REPLACE SUPPLIES STOP AT OUT*
STOP AT LOW
OVERRIDE AT OUT
Sets printer behavior when a cartridge is
low. The default is STOP AT OUT. This
option allows the printer to continue
printing until a color supply is exhausted.
When the printer is set to STOP AT
LOW, printing pauses until the color
supply is replaced. OVERRIDE AT
OUT allows printing to continue when a
color supply is out, but displays a
warning the supply is out and must be
replaced.
ORDER AT 0–100 Default=15
COLOR SUPPLY OUT STOP*
AUTOCONTINUE AT BLACK
Determine how the MFP behaves when
toner is out.
STOP: The MFP goes offline and waits
until the cartridge is replaced.
AUTOCONTINUE AT BLACK: The MFP
displays REPLACE CARTRIDGE until
the cartridge is replaced. The MFP
continues to print.
JAM RECOVERY AUTO*
OFF
ON
Determine how the MFP functions when
a jam occurs.
AUTO: The MFP automatically selects
the best mode for jam recovery
(usually ON). This is the default setting.
54 Chapter 2 Using the control panel ENWW