HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 290)

Control panel message Description Recommended action
REPLACE FUSER KIT
For help press
alternates with
REPLACE FUSER KIT
To continue touch "OK".
The fuser is nearing the end of its useful life
and the REPLACE SUPPLIES setting in
the SYSTEM SETUP menu is set to STOP
AT LOW. Printing can continue. 1. Order the fuser kit.
2. To continue printing, touch OK .
3. To replace the fuser kit, perform the
following steps:
● Open the top cover.
● Grasp the purple handles on the
fuser unit.
● Remove the old fuser unit from the
MFP.
● Install the new fuser unit.
● Close the top cover.
● Supplies ordering information is
also available from the embedded
Web server. See
Using the
embedded Web server for more
information.
REPLACE STAPLER
CARTRIDGE
● The stapler cartridge contains fewer
than 30 staples and should not be used.
The stapler cartridge needs to be
replaced.
● There is no stapler cartridge installed.
● Replace the stapler cartridge. For more
information, see
Supplies and
accessories .
● Install a stapler cartridge.
REPLACE SUPPLIES
For status touch "OK".
The supplies gauge will display the
consumption levels of print cartridges.
Multiple supplies are at the end of their useful
life. If the supplies affected are cartridges
only, printing has stopped because the
REPLACE SUPPLIES setting in the
SYSTEM SETUP menu is set to STOP AT
OUT. If the affected supplies are cartridges
only, printing cannot continue. 1. Touch SUPPLIES STATUS menu.
2. Scroll to the specific supply that has a
problem.
3. Touch to view help for the supply.
4. Use the scroll bar to step through the
instructions.
5. Supplies ordering information is also
available from the embedded Web
server. See
Using the
embedded Web server for more
information.
REPLACE SUPPLIES
Override in use
Press Status
alternates with
<Current status message>
OVERRIDE AT OUT is set in the REPLACE
SUPPLIES menu and at least one cartridge
is Out. Printing can continue.
CAUTION Using the Override
mode may result in unsatisfactory
print quality. HP recommends
replacing the supply when the
REPLACE SUPPLIES message
displays. HP Premium Protection
Warranty coverage ends when a
supply is used in Override mode.
Replace the indicated print cartridge.
270 Chapter 12 Solving problems ENWW