Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 106)

Section 4. Setting up Datalogger Networks
When configuring a TerminalServerPool, use the Terminal Servers tab to add
all the terminal servers that are connected to base modems that can be used to
call this site. The dialing string entered in the phone remote must work in
conjunction with any of the modems connected to the terminal servers added to
the pool for this datalogger.
For more information on modem pooling, refer to LoggerNet’s online help.
When using pooled modems, the modems should all be such that
any of the modems/phone lines could be used in conjunction with
any device that has it as part of its modem pool. Using the same
type – brand of modem is suggested. Also ensure that there is no
preference for phone lines that may be used (e.g. long distance
rates).
Hardware Tab
Standard
Communications Enabled – This check box is used to turn communication on
or off. This check box must be enabled for any communication to take place
over the TerminalServerPool.
Maximum Time On-Line – Enter a time limit for maintaining a connection to
the device. (This may be useful in avoiding costly communication costs, in the
event that a connection to a station is inadvertently maintained for a long
NOTE
4-50